Code Search

Please fill the "Code Box" to find engine fault code.

Car Models :

Please select your car.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

B0974 Engine Trouble Code

Meaning of B0974 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B0974 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for B0974 code is occuring now you should check B0974 repair processes.
Now don't ask yourself; What should you do with B0974 code ?
The solution is here :

B0974 Possible Solution:

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

B0974 Code Meaning :

B	0	9	7	4
OBD-II Diagnostic Body (B) Trouble Code For Engine	Intake Valve Control Solenoid Circuit Low	Injector Circuit Malfunction - Cylinders	Cylinder 10 Contribution/balance Fault	Timing Reference High Resolution Signal A Too Many Pulses

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

B0974 OBD-II Diagnostic Body (B) Trouble Code Description

B0974 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For B0974 Code

The reason of B0974 OBD-II Engine Trouble Code is Injector Circuit Malfunction - Cylinders.

B0974 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

	Example: 0140